chenzhufly 发表于 2016-1-21 15:58
还是把启动信息发上来嘛

U-Boot 1.1.3 (Jan 20 2016 - 09:58:33)

Board: Ralink APSoC DRAM:  16 MB
relocate_code Pointer at: 80fb4000
******************************
Software System Reset Occurred
******************************
spi_wait_nsec: 42
spi device id: c2 20 16 c2 20 (2016c220)
find flash: MX25L3205D
raspi_read: from:30000 len:1000
.raspi_read: from:30000 len:1000
.============================================
Ralink UBoot Version: 4.1.2.0
--------------------------------------------
ASIC 5350_MP (Port5<->None)
DRAM_CONF_FROM: Boot-Strapping
DRAM_TYPE: SDRAM
DRAM_SIZE: 256 Mbits
DRAM_WIDTH: 16 bits
DRAM_TOTAL_WIDTH: 16 bits
TOTAL_MEMORY_SIZE: 32 MBytes
Flash component: SPI Flash
Date:Jan 20 2016  Time:09:58:33
============================================
icache: sets:256, ways:4, linesz:32 ,total:32768
dcache: sets:128, ways:4, linesz:32 ,total:16384

##### The CPU freq = 360 MHZ ####
estimate memory size =16 Mbytes

Please choose the operation:
   1: Load system code to SDRAM via TFTP.
   2: Load system code then write to Flash via TFTP.
   3: Boot system code via Flash (default).
   4: Entr boot command line interface.
   7: Load Boot Loader code then write to Flash via Serial.
   9: Load Boot Loader code then write to Flash via TFTP.
0

3: System Boot system code via Flash.
## Booting image at bc050000 ...
raspi_read: from:50000 len:40
.   Image Name:   Linux Kernel Image
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    3830732 Bytes =  3.7 MB
   Load Address: 80000000
   Entry Point:  80363000
raspi_read: from:50040 len:3a73cc
...........................................................   Verifying Checksum
... OK
   Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80363000) ...
## Giving linux memsize in MB, 16

Starting kernel ...


LINUX started...

THIS IS ASIC
就到这里就不动了