电路设计

转录自己之前的一些关于PADS PCB设计技巧

2019-07-14 12:17发布

站内文章 / 电路设计
13126 0 1466
  1. set select filter ctrl+alt+F
  2. autofit view ctrl+B
  3. in crowd to select one thing,you could select sth near it,and press tab cyclely
  4. ctrl+enter to open option tab
  5. set and modify PCB outline.draw outline – select one side – pull arc – select shap – add miters
  6. during edit part type you could type “do” to visible drill hole
  7. move components and use space key as a left click
  8. type n24mhz,you colored the net 24mhz.type n again cancel the color before
  9. when routine press F4 you could add a pad and make a layer change at the last corner while shift+left click you add a pad at current point
  10. modless command ao to set angle mode as "O" and so on。。
  11. F3 for dynamic route. As a condition you must turn the DRC on before
  12. use find to find sth
  13. placing components with move sequential.-----chose select button right click –find –action:move sequential
  14. bus routing. you also need to make DRC on.when you add pad you can use ctrl+tab to change the shape of the pad
  15. creating split planes. assign color to net; set layer display; setting split plane options; chose power plane; select board outline; select shape; create plane area; drafting button; auto plane separate button; tool- plane manager- plan connect
  16. 只有开了drp才能动态绘图；bus布线需要先点中bus布线方式然后点pin选择模式再选一组pin，就可以开始bus布线了，你的鼠标引导一根线，当你点击左键，其他线自动跟上，通过tab键可以切换你引导的线。

热门文章