#error clnk Debugedp3.lkf:1 bad address (0x10b) for zero page symbol _LVDS_RX_PORT
#error clnk Debugedp3.lkf:1 bad address (0x10c) for zero page symbol _AUX_State
#error clnk Debugedp3.lkf:1 bad address (0x10a) for zero page symbol _is_HPD
The command: "clnk -m Debugedp3.map -l"C:Program FilesCOSMICCXSTM8Lib" -o Debugedp3.sm8 Debugedp3.lkf " has failed, the returned value is: 1
exit code=1.
# LINK COMMAND FILE AUTOMATICALLY GENERATED BY STVD:
# * TOTALLY IF AUTO MODE IS ENABLED
# * ONLY INSIDE MARKERS IN SEMI-AUTO MODE
#
# CHOOSE THE CUSTOM MODE IN STVD IN ORDER TO HAVE FULL CONTROL OVER THIS FILE.
#
# Sections delimited by <BEGIN ...> and <END ...> markers are reserved for
# STVD: DO NOT MODIFY INSIDE.
#
# Manual modifications are allowed OUTSIDE these sections, WHEN STVD AUTO MODE
# IS DISABLED.
#
# CAUTION:
# * Changing from Custom to Semi-Auto mode removes modifications in
# STVD-reserved sections
# * Changing to Auto mode removes all modifications.
#
# In Semi-Auto mode, you are allowed to remove <BEGIN ...> and <END ...> markers
# in order to gain control over the concerned sections. As a consequence any
# modification from the STVD graphical interface concerning this section will be
# ignored.
#
# Please refer to Cosmic User Manuals before any modification.
# Note that errors in editing this file may have unpredictable results when
# running STVD.
# Segment configuration - section reserved for STVD
#<BEGIN SEGMENT_CONF>
# Segment Code,Constants:
+seg .const -b 0x8080 -m 0x3f80 -n .const -it
+seg .text -a .const -n .text
# Segment Eeprom:
+seg .eeprom -b 0x4000 -m 0x400 -n .eeprom
# Segment Zero Page:
+seg .bsct -b 0x0 -m 0x100 -n .bsct
+seg .ubsct -a .bsct -n .ubsct
+seg .bit -a .ubsct -n .bit -id
+seg .share -a .bit -n .share -is
# Segment Ram:
+seg .data -b 0x100 -m 0x500 -n .data
+seg .bss -a .data -n .bss
#<END SEGMENT_CONF>
芯片是STM8S105K4 开发环境是STVP,有没人遇到类似问题,分享一下解决方法 谢谢
友情提示: 此问题已得到解决,问题已经关闭,关闭后问题禁止继续编辑,回答。
一周热门 更多>