Jlink V9 不支持RISC-V？-第2页回答

Jlink V9 不支持RISC-V？

2019-12-10 18:12发布

该问题目前已经被作者或者管理员关闭, 无法添加新回复

14条回答

1楼-- · 2019-12-11 11:44

自用配置文件：
telnet_port 4444
gdb_port 3333

#interface/ Dongle configuration
interface ftdi
ftdi_device_desc "Olimex OpenOCD JTAG ARM-USB-TINY-H"
ftdi_vid_pid 0x15ba 0x002a

ftdi_layout_init 0x0808 0x0a1b
ftdi_layout_signal nSRST -oe 0x0200
ftdi_layout_signal nTRST -data 0x0100 -oe 0x0100
ftdi_layout_signal LED -data 0x0800

transport select jtag

adapter_khz 1000
reset_config srst_only
adapter_nsrst_assert_width 100

#autoexit true

set _CHIPNAME riscv
jtag newtap $_CHIPNAME cpu -irlen 5 -expected-id 0x1000563d

set _TARGETNAME $_CHIPNAME.cpu
target create $_TARGETNAME riscv -chain-position $_TARGETNAME
$_TARGETNAME configure -work-area-phys 0x20000000 -work-area-size 20480 -work-area-backup 0

# Work-area is a space in RAM used for flash programming
if { [info exists WORKAREASIZE] } {
set _WORKAREASIZE $WORKAREASIZE
} else {
set _WORKAREASIZE 0x5000
}

# Allow overriding the Flash bank size
if { [info exists FLASH_SIZE] } {
set _FLASH_SIZE $FLASH_SIZE
} else {
# autodetect size
set _FLASH_SIZE 0
}

# flash size will be probed
set _FLASHNAME $_CHIPNAME.flash

flash bank $_FLASHNAME gd32vf103 0x08000000 0 0 0 $_TARGETNAME
riscv set_reset_timeout_sec 1
init

halt