在烧写程序的时候出现以下错误，我是用电池，ICD3
Connecting to MPLAB ICD 3...
Firmware Suite Version.....01.28.57
Firmware type..............Enhanced Midrange
Target detected
Device ID Revision = 5
The following memory area(s) will be programmed:
program memory: start address = 0x0, end address = 0x3fff
configuration memory
Programming...
program memory
Address: 1 Expected Value: 3184 Received Value: 0
Failed to program device

有没有人知道原因啊，在线等，谢谢！